A Quick and Easy Guideline to What is Three-plate Mold

A Quick and Easy Guideline to What is Three-plate Mold
According to the feeding system, plastic injection molds can be divided into two categories, cold runner system molds and hot runner system molds.

Based on the number of steel plates, there are two plate mold and three plate molds.

Three plate mold is is generally composed of three pieces of steel plate as shown below.

A Quick and Easy Guideline to What is Three-plate Mold

THREE-PLATE MOLD is usually structured with a point point gate and it is used for automatic degating and center gating on multi-cavity molds. Three-plate molds are less expensive than hot runner molds and there is also a runner left over. An advantage to gating with a three-plate mold eliminates the need for cutting the gate off the part. Some multi-cavity molds must have a center gate on each part. A three-plate mold is the most economical way to achieve this.

A Quick and Easy Guideline to What is Three-plate Mold

Generally, there are pros and cons of three-plate molds

Pros of three plate molds
Cost less to build than a hot-runner system mold
Less likely to break down than a hot-runner mold
Thermally sensitive materials are less likely to degrade
Gate is easily moved on the part and edge gate mold

Cons of three-plate molds

Longer cycle time due to ejection of the runner system
More material is wasted due to extra feeding plate for runner system
Greater injection pressure is required to fill the mold and larger press is required.

Related News

Leave a Reply

Your email address will not be published.

Mobile

0086-186-8868-3865

Email
SHARE
TOP
Follow us on Social Media